Silverline 427558 - Troubleshooting

EN
8
Problem Possible Cause Solution
Tool operating slowly
Pressure incorrect Setthecorrectairpressureaccordingtothe‘Specications’
Dirt within the mechanism Pour air tool oil into air inlet as per maintenance instructions
Air blockage Operate tool in short bursts to clear blockage
Air leak
Checkallttingsandhoseforairleaksandcorrectissueby
re-tightening, using PTFE tape or replacing
Blockageingauzemeshlter RemoveQuickConnector(4)andcleanmeshlter
Tool seized Dirt or rust in mechanism
Try ‘Tool operating slowly’ solutions
Tap tool gently with a soft mallet
Tool will not stop after Trigger (3) is fully released Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
Gun fails to operate Air pocket Follow ‘Bleeding the grease chamber’ instructions above
No grease dispensed Plunger mechanism not released Press the Plunger Release (6)
Low amount of grease being dispensed
Compressor pressure low
Increasecompressorairpressurewithintherangespeciedin
‘Specications’
Grease level in chamber low Re-llchamber
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
427558_OwnerManual.indd 8427558_OwnerManual.indd 8 16/01/2024 08:5916/01/2024 08:59