SYSTEM OPERATIONS-61
SHIFT/THROTTLE CONTROL
SYSTEM (GLENDENNING CON-
TROLS) (OPTIONAL)
You may have chosen as an option when
you purchased your 43SB, an electroni-
cally controlled Shift/Throttle Control
System, factory installed at the Silverton
plant. The purpose of this system is to
provide the operator with smooth, posi-
tive shift and throttle operation requiring
minimal manual effort. With this system,
only one (1) shift/throttle control lever is
required per engine; the left control lever
operates the Port engine and the right
control lever operates the Starboard en-
gine.
The Glendenning Shift/Throttle Con-
trol System is operated on DC Electrical
Power, controlled by a breaker switch
located on the DC Electrical Panel and de-
scribed as “Accessory” (Refer to the Elec-
trical Pages in this section of this Owner’s
Manual for the switch location).
Refer to the GLENDENNING CON-
TROLS, INC. Manual included with your
Owner’s Packet for additional technical
information concerning the operation
and maintenance of the GLENDENNING
SHIFT/THROTTLE CONTROL SYSTEM.
To Next Page