ENGLISH
10. ELECTRICAL CONNECTION
The extension cable used to feed the machine needs to have a minimum section of 4x2.5 mm
2
up to 25
meters long. For a superior distance 4x4 mm2 can be used. In one of its ends, it is needed to connect a base
normalised ae P+T ó 16A 2P+T comp ine switch and in the ot normalised
aerial pin of 16A 3P+T ó 16A 2P+T compatible with switchboard exit.
nge the position of the bridge plates in th rtant
reflect the change made g the
changing the voltage.
11. SAFETY RECOMMENDATIONS
s to be connected to normalised switch board that is
quipped with a magneto-thermic and a differential that comply with the characteristics of the
3 CV, singl hase at 230v, gneto-the 300mA.
CV, thre at 400V, to-thermi nd a diffe mA.
Stirrups bending machines model Star-16 are to be used by trained people or people familiarized with their
peration.
chine please read the instructions and make sure safety norms are respected.
ine in a fast and safe way.
• Place the machine on a plane surface. Connect the machine to the electricity only when you are sure
ly o a
• It is recommended to use safety glasses, safety boots, gloves etc. Please always use approved
erials.
s use dividual Protec Equipment (IPE in accordance wi the type of wo you are
effectuating.
Prohibit stra ers to access th ce of work of the machine.
• Work clothes are not supposed to have loose articles that can cling into movable parts of the
machine.
• When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
• Always keep protection elements and the safety guards in their correct positions.
• Damaged electrical cables should be urgently replaced.
• Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor
electrical elements of the machine while the engine is on.
• Never use the machine for purposes other than those it has been designed for.
rial of 16A 3 atible with the mach her end, one
IMPORTANT: It is appropriate to cha
to change the adhesive labels indicating
machine before
e engine terminals. It is also impo
. It is very important to unplu the voltage, to
• Machines with an electrical motor are alway
e
motor:
2.2KW/
1.5/2
e-p
e-phase
ma
magne
rmic of 20 A and a di
c of 10A a
fferential of 20A/
rential of 10A/300
o
Before starting up the ma
Learn how to stop the mach
• Start the machine on when you have m unted the safety gu rds that come with the machine.
mat
• Alway In tion ) th rk
• ng e pla
10
To Next Page
Loading...
