ENGLISH
• Lubricate weekly with calcium grease the holes where the bolts are housed and the bottom of the
of the belts of the motor each 6 months. The correct tightening of the belt is
sed as it has already grease inside for it whole life.
ug it and let a technician review it.
CHANGING THE BELTS
e factory with the belts perfectly tightened. It is possible that the installation of
the mach
1. ake sure the machine is unplugged from the power supply.
.
motor to be displaced.
htening screws.
to be checked and if needed tightened after a certain period
of work as
5. CONTROL PANNEL
lectrical tension entry to the machine.
tion of the rotation of the bending plate.
with
the plate piv
ot tension and has selected a sense
of rotatio
g.5 Orange button: we use this button when we release the pedal, push the emergency button or when
an error i
5.1 PARTS OF THE BENDING PLATE
.6 where to insert the thrust bolt, two twisted holes B, Fig. 6 used to
extract th
5.2 INVERSION PIVOT AND ANGLE SELECTION
ate rotation angle.
bolt to avoid corrosion.
• Review the tension
that which allow a shaft of 1,5 to 2 cm. Fig. 3.
• The reducer group does not need to be grea
• Cables causing breaks or cuts should be urgently changed.
• In case of anomalies in the functioning of the machine, unpl
• At the end of each day, unplug the machine and cover it with a waterproof cloth.
4.1
The machines leave th
ine and by using it for a long time, the belts get loose. To tighten back the belt or replace it, please consider
the following steps.
M
2. Remove the back and front doors of the frame of the machine
3. Loosen with a key the four screws (A, Fig.4) just enough for the
4. Depending on what we want to do, tighten or change the belt, we have to deal with the tig
(B, Fig. . When tightening, make sure all belts have the same tension.
4)
5. Once the belts have been tensed, you can fasten back the screws.
6. Place back the inferior frame safeguard.
IMPORTANT: Transmission belts are
these belts can lose their tightness because of temperature and long hours of work.
A, Fig.5 Switch Plug: e
B, Fig.5 Bending plate direction Selector: It selects the direc
C, Fig.5 Angle adjustment wheel: It is used to regulate the accuracy of the angle that we cannot get
ot. Its function is also to advance or retreat the bar mandrill support.
D, Fig.5 Green pilot: The ignited pilot indicates that the machine has g
n.
E, Fi
n operating the machine happens and we want the bending plate to go back to its point.
F, Fig.5 Emergency stop: It is used to stop the machine in case of emergency.
Pedal. It is used to confirm the rotation of the bending plate. Fig.9
The bending plate has a hole A, Fig
e plate, one hole C, Fig.6 where for the central bolt and a holes sector D, Fig.6 for the inversion pivot.
The inversion pivot (Fig. 8) is used to select the pl
7
To Next Page
Loading...