Why Sima DEL-32 doesn't have enough power to cut or bend?
If your Sima Industrial Equipment lacks power for cutting or bending, several factors could be responsible. Check for loose or damaged belts and tighten or replace them as needed. Inspect the blades for damage; replace them or try using the other cutting side. Also, verify that the motor is receiving the correct current; if not, schedule a technical service check for the engine.
What to do if the pilot light is on but the Sima DEL-32 Industrial Equipment doesn't work?
If the pilot light is on but your Sima Industrial Equipment isn't working, there are a few things to check. First, ensure that the machine is correctly connected and that all phases are complete. Also, check the fuse in the machine's electrical box. Make sure the emergency stop button is not depressed. Finally, verify that all security features are correctly in place, including doors, emergency stop buttons, and the plastic table top guard.
Why the bending plate doesn’t stop immediately when the pedal is released on my Sima DEL-32 Industrial Equipment?
If your Sima Industrial Equipment's bending plate doesn't stop immediately when the pedal is released, it could be due to a worn motor brake. Inspect the motor brake and tighten the springs, ensuring a uniform gap between the disc and the plate of .3 to .4mm. If the motor brake is not operational, consider replacing it.
What to do if Sima DEL-32 doesn’t have enough current and the pilot light doesn’t come on?
If your Sima Industrial Equipment isn't receiving enough current and the pilot light doesn't come on, start by checking the site junction box to ensure electricity is being produced. Verify the current from the mains. Check the fuse on the junction box and re-arm it if necessary. Finally, inspect the cables and replace them if they are in bad condition.
Why the bending plate doesn´t return to its original position after the bend is complete on my Sima Industrial Equipment?
If your Sima Industrial Equipment's bending plate doesn’t return to its original position after bending, the inductive sensor might be defective. Check the sensor (1 open, 0 closed) and replace it if damaged.
How to fix oil leak from the gearbox of Sima DEL-32?
If your Sima Industrial Equipment loses oil through the gearbox, the rubber washer might be deteriorated. Replace the rubber washer to resolve this issue.
What to do if the plate doesn't stop at the original position after bending with Sima DEL-32?
If, after bending, the plate on your Sima Industrial Equipment doesn't stop at the original position, the inductive sensor may be defective. Check the sensor (1 open, 0 closed), and replace it if damaged.
Why Sima DEL-32 Industrial Equipment doesn’t have enough power despite correct 230v or 400v connection?
If your Sima Industrial Equipment doesn't have enough power even with the correct 230v or 400v connection, the electricity supply might be unstable. Verify that the voltage is not inferior to 230v or 400v, as the machine won't work correctly under that voltage. Using a tension stabilizer is recommended.
What causes a strange noise from within the gearbox of Sima Industrial Equipment?
If you notice a strange noise coming from the gearbox of your Sima Industrial Equipment, it could be due to the deterioration of some internal components. Dismantle the gearbox and inspect the bearings and grooves, replacing any damaged elements.
Electrical connection requirements, cable specifications, and safety notes.
Step-by-step guide to safely connect the machine to the power supply.
Overview of the machine's electrical diagrams and wiring schematics.
Operating the machine via the mobile app in automatic mode.
General| Brand | Sima |
|---|---|
| Model | DEL-32 |
| Category | Industrial Equipment |
| Language | English |
To Next Page