9 For COMBI models, there are two greasing points that should be greased every 20 days.
12.1 CHANGING THE BELTS.
The machines leave the factory with the belts correctly tightened, however it is possible that after a few days
of work the belts become loose. To tighten the belts again the process is the same.
1. Make sure the machine is disconnected from the electricity supply.
2. Remove the side panel of the machine.
3. the 4 bolts that hold the platform to the guide.
4. Tighten the belt with the tightening mechanism.
5. Retighten the bolts.
6. Replace the side panel of the machine.
To Next Page
Loading...