Remote blocking on. Active program.
Name of program. Calibration by angle adjustment.
Introduction of bending angle. Deleting bending angle.
Number of bars bent. Load program.
Void program position. Press emergency stop button
(Test mode).
Press the pedal Open and close front door
(Test mode). (Test mode).
Lift and pull down Pull down cutting head cover
guard screen (Test mode). limit switch (Test mode).
Step on the pedal and keep the Press reverse button
inversion pin inserted (Test mode). (Test mode).
Component status (Test mode): Component status (Test mode):
Emergency stop button. Pedal.
Component status (Test mode): Component status (Test mode):
Door limit switch. Protective cover limit switch.
To Next Page
Loading...