Simco-Ion scorpION3 - Page 51

scorpION3 5200969 Rev 4 46
DIAGNOSTIC NAVIGATION
feedback
fault status accumulators
bar information
*reset bar command
PRESET NAVIGATION
*select preset number (P01, P02,…P14)
power
output
pulse/steady state
slave/independent
1
pulse time
1, 2
overlap
1
balance
fault threshold
HV on/off w/fault
fault contact
*save as preset
*upload to bar
1
not present if in steady state
2
not present if slave
* Hot Keys are NOT enabled
UPLOAD PRESET NAVIGATION
*select bar
*enter=execute (transmit preset settings to bar)
SYSTEM MONITOR
*MMI screens rotation showing fault status code for each bar
(MMI LED’s indicate bar fault status).
IR MODE NAVIGATION
*select bar or preset
IR ACQUISITION (1st READBACK)
*Point MMI at bar & press enter
*accept bar address
*select settings or diagnostics
IR SETTINGS NAVIGATION
power
output
pulse/steady state
slave/independent
1