scorpION3 5200969 Rev 4 47
pulse time
1, 2
overlap
1
balance
fault threshold
HV on/off w/fault
fault contact
*save local to bar
*save as preset
1
not present if in steady state
2
not present if slave
IR DIAGNOSTICS NAVIGATION
feedback
fault status accumulators
bar information / serial number
*reset bar command (point MMI & enter=execute)
ADDRESS TEST
*searching for address conflicts
*accept or change address conflicts
*change desired address
HOT KEYS
* Hot Keys are NOT enabled
up & left jump to top of menu
up & right jump to save settings local to bar
down & right jump to fault status accumulators
down & left jump to feedback (program, current , drive monitors)
left & right jump to balance adjustment
To Next Page
Loading...