Simfer SYD 150 MD DC - Operation of the Freezer

19
instructions. Use only genuine Simfer spare parts.
Non-genuine spare parts may cause risks for you and may damage
your product.
Place your product where you desire. Consider the placing rules spec-
ied in the manual during placement.
Level your product laterally and vertically with a spirit level. Perform
the levelling procedure with the adjustable legs on the front lower part
of your freezer.
OPERATION OF THE CONSERVATOR
Rules for Electrical Connection
Your product shall operate when you plug it to an outlet.
CAUTION!
Do not plug your product to a multi-socket or do not use an exten-
sion cord.
Your product is not equipped with an on/o switch.
Do not allow the cables of your product connected to the mains to
contact hot surfaces. Outlet that shall be used shall always be ground-
ed. It the outlet that shall be used shall also be protected with a proper
fuse with a rating of 10-16 A minimum. Always get support from our
authorized service or a qualied electrician for the fuse that shall be
installed on the electrical installation where the outlet is connected.
(Figure 6)
The voltage and frequency of mains power should be the same as the
values specied on the label on the inner surface of your product. If
mains power is far below or above the specied value, have the desired
voltage by using a voltage regulator.
You can get help from a qualied electrician.
Do not put the cable of your product on passage routes. These may
cause injury to you and damage to your freezer.