Simfer SYD 150 MD DC - What to Do before Calling for Authorized Service

25
WHAT TO DO BEFORE CALLING FOR AUTHORIZED SERVICE
Failure Possible Solution Result
If the freezer does not
operate (No noise or
just the fan noise)
It may be caused by
the thermostat. It may
be unplugged. Fuse
may be blown or faulty.
Condenser ns may be
dirty or clogged.
It shall operate again
when it reaches the
proper temperature.
Plug it correctly. Con-
sult Simfer authorized
service or a qualied
electrician.
Internal temperature of
the product is high
Ambient temperature
is very high or thermo-
stat setting is incorrect.
Rear part is very close
to the wall, ventilation
blinds are blocked or
its front is covered. It
may be exposed to ex-
cessive external wind.
Condenser ns are very
dirty
Take your freezer to a
place where ambient
temperature is lower.
Bring it to specied
clearance. Clean the
front of the ventilation
blinds. Prevent wind.
Clean the condenser
ns.
Internal temperature
of your product is very
low
Wrong internal ther-
mostat setting
Reset the thermostat.
Excessive perspiration
inside the product and
on the window.
Water drainage hole
may be clogged for in-
ternal perspiration. Hu-
midity level of external
environment is higher
than 65% for perspira-
tion on the window.
Clean the water drain-
age hole. For high hu-
midity conditions, you
may place your freezer
in a location with less
humidity.
Bad odours can be
smelt under your freez-
er.
Lower water drainage
tray is dirty. (Applies to
some models.)
Clean the water drain-
age tray.
Power ratings of the lamps or LEDs used in your products are
specied on the plate inside the freezer or in the installation area of the
lamps. Lamps and LEDs used in your products should only be operated
on by Simfer Authorized Services.