www.simondstore.com Page 7 of 13
Ÿ Connect Gas regulator with the propane Cylinder. Don't forget that pressure regulator has left thread. Check
that there is no loose fitting of parts which may lead to gas leakage.
Ÿ Light up the forge by using lighter at the opening of the burner inside the forge body.
Ÿ Now Forge is ready for the firing.
Why this gap filling is necessary?
Ÿ To Prevent the heat loss.
Ÿ Heat Loss damage this area of
furnace.
Pre-Rigidized
Ceramic Fiber
Insulation.
To Next Page
Loading...