Simonelli Aurelia - Page 56

54
ENGLISH
TANDARD DOSES
• When the display reads:
we mean to recall the standard dose values.
• Press the key.
The display will read:
Once again the delivery buttons will begin to
flash (see. Fig. 29) on and off.
• Select one or more continue keys (the key
or keys selected will remain lit up).
The key or keys will recall the selected uni-
t’s standard doses.
• Press the key to confirm.
The display will read:
NOTE: all the selections can be programmed
for a maximum of two minutes; after
that time a flashing message will
appear on the display saying:
DELIVERY COUNT
• The display will read:
• Press the key to confirm.
At this point the display will read:
• Press the or the key to
exit without confirmation.
TRANSFERRING DOSES
• When the display reads:
transferring the set dose to other units is
possible by pressing the key.
The display will read:
at this point all the delivery buttons belon-
ging to each individual unit will flash as illu-
strated in Fig. 31.
• By selecting the continue key once on
the first unit ( the key will stop flashing but
remain lit up), the set values will be trans-
ferred from the first unit to the other units.
Fig. 29
PROGRAM DOSES
SELECT
DOSES TRANSFER
SELECT GROUPS
DOSES TRANSFER
SELECT GROUPS
DEFAULT SETING
SELECT GROUPS
PROGRAM DOSES
SELECT
• By pressing the key the display will
read:
• All the delivery keys will start to flash on and
off. By pressing one of the delivery keys the
amount of the deliveries made will be visua-
lised.
• To set the counter back to zero, press the
key.
NOTE: The continuous coffee equals one deli-
very.
• Press to access waiter counts (if
provided).
• Press the key and the display will
read:
All the units’ small coffee keys will begin
to flash on and off.
Example:
By selecting one of the first unit’s keys (the
selected key will remain lit up) the display
will read:
which means the total amount of deliveries
for that unit.
• To set the counter back to zero press
.
• To access the waiter counter press .
• When the display reads:
press and the display will read:
PROGRAM DOSES
SELECT
ERROR
DELIVERY COUNT
SELECTION TOTAL
GROUP TOTAL
GROUP TOTAL
GR. 1 DELI.
GROUP TOTAL