62
ENGLISH
To switch the machine off press the main switch
and set the machine to the O energy position.
The machine must be set to “O” power (switch
off and disconnector open) before any cleaning
operations are performed.
Do not use solvents, chlorine-based pro-
ducts or abrasives.
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath
and clean everything with hot water and clean-
sers.
Cleaning the bottom: To clean all the chro-
mium-plated areas, use a soft, damp cloth.
8.1
SWITCHING OFF THE
MACHINE
8.2
CLEANING THE OUTSIDE
OF THE MACHINE
8.3
CLEANING THE STAIN-
LESS COFFEE-HOLDERS
Fig. 30
The stainless coffee-holders are situated under
the delivery units, as shown in figure (31).
Fig. 31
NOTE: To clean proceed as follows:
• Turn the screw placed in the centre of
the coffee-holder.
• Slide the coffee-holder out and check
that its holes are not obstructed but
clean.
• If obstructed, clean as described
(Paragraph “CLEANING FILTERS
AND FILTER-HOLDERS”)
We recommend cleaning the coffee-
holder once a week.
Aurelia Version
V/ESSE
Aurelia Version
Vip/V/ESSE
WARNING
8. CLEANING AND MAINTENANCE
CAUTION
RISK OF INTOXICATION
8.4
CLEANING THE UNIT
WITH THE AID OF THE
BLIND FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
The machine will initiate washing cycle which
consists in the circulation of hot water followed
by regular breaks.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
Once the filter-holder has been removed,
repeat delivery operations a few times to eli-
minate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
1) Substitute the filter with the delivery unit
blind filter.
2) Fill it with two spoonfuls of special cleanser
powder and insert it into the unit filter-holder.
3) Press one of the coffee keys and halt it after
10 seconds.
4) Repeat the procedure several times.
5) Remove the filter-holder and carry our a few
deliveries.
8.5
CLEANING FILTERS
AND FILTER-HOLDERS
Place two spoonfuls of special cleanser in half
a litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.
It is not possible to clean the machine using
water jets or standing it in water.
WARNING
During maintenance/repairs, the parts used
must be able to guarantee compliance with the
safety and hygiene requirements envisaged for
the device.
Original replacement parts can offer this gua-
rantee. After repairs to/replacement of a part
that comes into contact with foods or water, it is
necessary to carry out a washing procedure or
to follow the steps indicated by the manufactu-
rer.
To Next Page
Loading...
