Manual – Digital locking cylinder 3061
Page 29
11. Data sheet
Knobs Material Stainless steel
Colours Satin stainless steel
Diameter 30 mm
Length 37 mm (from profile face)
FH cylinder knobs Material Internal knob: cap stainless steel
Recessed grip area plastic
External knob: identical to standard cyl.
Colours Cap: satin stainless steel
Recessed grip area black
External knob identical to standard cyl.
Diameter 30 mm
Length 37 mm (from profile face)
AP cylinder knobs Material External knob: identical to standard cyl.
Internal knob: Aluminium
Colour External knob: satin stainless steel
Internal knob: nickel-plated aluminium
Diameter 30 mm
Length External 37 mm (from profile face)
Internal: ca. 36 mm (from profile face)
AP cylinder knobs Material External knob: identical to standard cyl.
Internal knob: identical to standard cyl.
Colour External knob:
Cap: gloss brass
Recessed grip area: matt brass
Internal knob:
Cap: brass gloss
Recessed grip area: brass matt
Diameter 30 mm
Length 37 mm (from profile face)
Profile cylinder Basic length External 30 mm, internal 30 mm
Design lengths in increments of 5 mm
(no kits) up to an overall length of 140 mm
whereby one side of the cylinder can have
a maximum length of 90 mm.
Longer lengths available on request.
Profile cylinder AP / WP Basic length External 30 mm, internal 35 mm
Design lengths in increments of 5 mm
(no kits) up to an overall length of 140 mm
whereby one side of the cylinder can have
a maximum length of 90 mm.
Longer lengths available on request.
To Next Page
Loading...
