PinCode Keypad 3068
Page 12
6.3 Procedure
7.0 Reading out Transponders
Anytime it is possible to read out the integrated transponders (after they were
programmed) with the SimonsVoss locking plan software.
7.1 Description
To do this, proceed as follows:
1. Start the "Read out transponder" function in the SV software
2. For the particular transponder:
• Transponder 1 = enter "PIN 1"
• Transponder 2 = enter "PIN 2"
• Transponder 3 = enter "PIN 3"
7.2 Procedure
Input "00"
Transponder 1 =
press "1" button
Transponder 2 =
press "2" button
Transponder 3 =
press "3" button
Start “Transponder programming” function in the
SV
software!!!
Input "master PIN“
Input "PIN 2"
Start the "Read out transponder"
function in the SV software
Input "PIN 3" Input "PIN 1"
To Next Page
Loading...
