14
Operating Instructions
1) Switch on water heater
Switch on power supply of water heater and press ON/OFF button on
front panel control .
Temperature display lights up and the water heater is ready for use.
After new installation, default temperature of 42℃ will be displayed for
the first time usage.
2) Select hot water temperature
Press “ ”button for a higher temperature or press “ ”
button for a lower temperature.
Water temperature can be adjusted from 35℃ to 60℃ and shown on
the temperature display.
3) Use of hot water
When turn on hot water tap, water heater operates automatically, in use
indicator lights up.
When hot water flow is less than 2.5 L/min, the burner will be shut down.
When water heater is operating, hot water temperature cannot be set
above 48℃.
When water heater is operating and temperature setting is 50℃ or
above . High temperature indicator lights up and temperature setting
can only be decreased .
4) Stop operation
Turn off hot water tap, water heater stops operating and in use indicator is off.
Press the button to switch off the water heater. The temperature display and all
indicator lights will be off.
Caution
To prevent scalding, check water temperature with your hand before use. Do not direct water onto the
head or body.
When you turn on the tap again after using high temperature hot water, there is a risk of being scalded
as high temperature water may in the water pipe. Check water temperature with your hand before use.
Turn off the power supply, the water inlet valve and the gas valve when the heater is not to be used for
a long period of time.
Control of Hot Water Temperature
Turn off hot
water tap
Temperature
display
ON/OFF button
In Use indicator
High temperature
indicator
Increase water temperature
Decrease water temperature
Dishwashing
temperature
Shower
temperature
High
temperature
To Next Page
Loading...
