1 x Left and right mover unit
1 x Connection bar, 2 x mounting clamps including fitings
1 x Remote control with 2 x AA batteries, 1 x HD Controller, antenna and green connector set
1 x 1.5 meter red cable 10 mm
2
/ 1x 1 meter black cable 10 mm
2
18 x Screws 4 x 20 mm
4 x Yellow electrical terminals for the motor cables
6 x Black Tie wraps
1 x 5 meter black flexible protection hose
1 x Caution sticker "Release rollers"
1 x 1 meter red cable 1 mm
2
1 x Power main switch with 3 x solder terminals
1 x Socket screw driver
1 x 4 meter purple cable 1 mm2
1 x 4 meter brown cable 1 mm
2
Installation instructions
• Measure the length of the connection bar and mark the center of the connection bar (75 cm)
• Measure the track width of the caravan
• Connect the left and right mover unit together by means of the connection bar and make sure that the marked
point on the connection bar is located in the middle. (See fg.1)
• Set the mover units on the measured track width
Fig. 1
• Place the mounting clamps (see fg. 2 ) on the sub-frame and add the top plate.
• Use a support to press the movers to the chassis of the caravan.
• Slide the mounting clamps aside to the caravan chassis and tighten the clamps as per instructions
If necessary, SimPark has several mounting plates for different types of chassis in stock
To Next Page
Loading...