Switch on the Controller
When the remote control has been recognized by the main Controller, it will be activated.
After one beep the cooling fans start to run, the system is now ready to use.
The Controller and remote control switch off automatically after 60 seconds after the last given command.
Safety features of the Controller
Temperature protection
The Controller goes into "safety" mode when the PCB has reached a temperature of +/- 75 degrees Celsius.
The Controller will return automatically to its program when the temperature has been decreased with 15
degrees Celsius.
Low
voltage
protection
The Controller goes into the "safety" mode when the voltage drops under 8,5 volt.
After 30 seconds the Controller will return automatically to its program when the voltage becomes
higher than 8,5 volt.
Emergency function to retract the drive-rollers
If the drive-rollers are pressed to the tyres and an electrical failure occurs, please read the next instructions.
Remove the rubber cap on the backside of the protective cover. Insert the screw-driver socket in the hole and
turn it clockwise to retract the drive-rollers from the tyres.
Status legend
To Next Page
Loading...