Simplex 4100-5111 SPS

To Next Page

SPS/RPS

Installation Instructions



Specifications and other information shown were current as of publication and are subject to change without notice.

Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.

579-246

Rev. K

This publication describes the installation procedure for the following 4100-Series System Power

Supplies (SPS) and Remote Power Supplies (RPS):

 4100-5111/5112 SPS (120 VAC) (mounts to expansion bays only)

 4100-5125/5126 RPS (120 VAC)

 4100-5113 SPS (220/230/240 VAC) (mounts to expansion bays only)

 4100-5127 RPS (220/230/240 VAC)

These products are compatible with 4100U and 4100ES Fire Alarm Control Panels

(FACP).

IMPORTANT:

 The SPS described in this document are not physically the same as the SPS

used in the CPU bay.

 Verify FACP System Programmer, Executive, and Slave Software compatibility

when installing, or replacing system components. Refer to the Technical

Support Information and Downloads website for compatibility information.

This publication discusses the following topics:

Topic See Page #

Cautions and Warnings 2

Introduction to the SPS and RPS 3

Mounting 7

Configuring the SPS and RPS 8

Internal Wiring 10

NAC Field Wiring 12

IDNet Field Wiring (SPS only) 23

Auxiliary Power Wiring 26

Auxiliary Relay Wiring 29

Troubleshooting 31

City and relay connections can be made from the SPS (the RPS supports relay connections only).

Refer to the City and Relay Card Installation Instructions (574-839) to install a relay card to the

SPS, or a city card to the SPS or RPS.

To find out more about the CPU bay version of the SPS, which operates in the same way as the

expansion bay version of the SPS but mounts differently, refer to the 4100ES Fire Alarm System

Installation Guide (574-848).

For information on Expansion Power Supplies (XPS), refer to XPS and XNAC Installation

Instructions (574-772).

Introduction

In this Publication

Documentation

firealarmresources.com

Main Page

Need help?

Do you have a question about the Simplex 4100-5111 SPS and is the answer not in the manual?

Summary

Safety and Compliance Information

General Safety and Installation Precautions

Emphasizes reading instructions, inspecting for damage, and handling static electricity.

Introduction to the SPS and RPS

Input;Output and Battery Specifications

Details AC input, DC output, and battery charger specifications for the SPS/RPS.

Configuring the SPS and RPS

Jumper and DIP Switch Settings

Details jumper configurations for fault monitoring and IDNet shield, and DIP switch for device addressing.

NAC Field Wiring

Class A and Class B Wiring Diagrams

Detailed instructions and diagrams for connecting notification appliances using Class A and Class B configurations.

IDNet Field Wiring (SPS only)

IDNet Class A and Class B Wiring

Provides specific wiring instructions and diagrams for connecting IDNet devices using Class A and Class B configurations.

Troubleshooting System Faults

Common System Faults and Resolutions

Lists common display messages, their causes, and required actions for system faults.