4100U Remote Annunciators
Installation Instructions
© 2006 Tyco Safety Products Westminster, Westminster, MA 01441-0001 USA
All specifications and other information shown were current as of document revision date, and are subject to change without notice.
Tyco, Simplex, and the Simplex logo are trademarks of Tyco International Services AG or its affiliates in the U.S. and/or other countries.
579-271
Rev. G
This publication describes the installation procedures for the following PIDs:
• 4100-9607 Remote Annunciator w/ Flexible User Interface – Domestic
• 4100-9608 Remote Annunciator w/ Flexible User Interface - Canadian
• 4100-9609 Remote Annunciator w/ Flexible User Interface - International
• 4100-9610 Remote Annunciator
• 4100-9611 Basic Remote Annunciator
• 4100-9612 Basic Remote Annunciator w/ Flexible User Interface - Domestic
• 4100-9613 Basic Remote Annunciator w/ Flexible User Interface - Canadian
• 4100-9614. Basic Remote Annunciator w/ Flexible User Interface - International
IMPORTANT: Verify 4100U system programmer, executive, and slave software
compatibility when installing or replacing system components. Refer to
solution bulletin SB01014 for compatibility information.
Upon unpacking your Simplex product, inspect the contents of the carton for shipping damage. If
damage is apparent, immediately file a claim with the carrier and notify an authorized Simplex
product supplier.
This publication discusses the following topics:
Topic See Page #
Cautions and Warnings 2
Remote Annunciator Installation 3
Power Requirements (4100-9610 and 4100-9611)
Input Voltage 19-33 VDC
Input Current 87 mA standby or alarm
Power Requirements (all models with Flexible User Interface)
Input Voltage 24 VDC
Input Current 186 mA standby, 214 mA alarm
Environmental Specifications
Operating Temperature
32° to 120° F (0° to 49° C)
Humidity
Up to 93% relative humidity at 90° F (32° C)
Introduction
Inspecting Contents
of Shipment
In this Publication
Specifications
To Next Page
