Need help?Do you have a question about the Simplex 4010 and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Power Supply | 120/240 VAC, 50/60 Hz |
| Manufacturer | Simplex |
| Model | 4010 |
| Battery Backup | 24 VDC |
| NAC Outputs | 4 |
| Max Detectors | 250 |
| Max Modules | 250 |
| Operating Temperature | 0°C to 49°C (32°F to 120°F) |
| Humidity Range | Up to 93% RH, non-condensing |
Disconnect electrical power before internal adjustments or repairs. Service by qualified representatives.
Details the control panel's LCD, LEDs, and operational/programming keys.
Step-by-step instructions for removing the chassis and preparing conduit entrances.
Instructions for surface and semi-flush mounting the backbox to the wall.
Details the procedures for connecting AC power and system batteries safely.
Describes steps for applying power and verifying system operation after installation.
Outlines procedures for a complete operational test to verify NFPA standards compliance.
Resets the configuration and adds all currently connected devices to the CFIG.
Restores the 4010 to its original factory default configuration.
Saves all configuration changes made during programming to the CFIG.
Describes procedures for managing optional cards within the 4010 FACP.
Details the steps required to begin and navigate a Custom Control programming session.
Explains how to access and run diagnostic utilities for communication lines and devices.
To Next Page
