6-22
Table 6-9. User-Defined SW/LED Configuration Choices
Function Description
Edit Device Type
(See Notes 1 and 2)
Changes the Hardware Device Type of the Point
Edit Point Type
(See Note 2)
Changes the Software Point Type of the Point
Edit Point Label
(See Note 1)
Changes the 40-Character Label of the Point
Clear Point Label
(See Note 1)
Blanks the 40-Character Label of the Point
Edit Mode Changes the Mode of Operation for the Point
Notes:
1. This function not allowed for User-Defined SW/LED.
2. Your Point Type choices for LEDs are Yellow LED or NON-
Yellow LED. The switches default to USWITCH point type and is
not editable.
This section describes how to edit the mode of a User-Defined SW/LED. Use
the following steps to edit the mode of a User-Defined Switch or LED in the
4010 FACP.
1. After selecting User Defined SW/LED as your option under the Configure
Points menu, press <NEXT> or <PREVIOUS> to scroll through the
choices listed below. Once your choice is displayed, press Enter.
• User LED 1
• User LED 2
• User LED 3
• User Defined Key 1
• User Defined Key 2
2. Press <NEXT> or <PREVIOUS> to scroll through your list of choices until
Edit Mode is displayed and then press Enter. Your modes for Switches and
LEDs are shown in Table 6-10.
Continued on next page
Configuring User-Defined SW/LED, Continued
Configure a User-Defined
Switch or LED (continued)
Edit a Mode of a User-Defined
SW/LED
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
