10-2
The 4010 has the capability to run diagnostics of the N2 communication lines,
the IDNet channel, the Network communication lines, and to locate an Earth
Fault between IDNet devices. This section shows how to run the diagnostic
utility on the 4010.
Running diagnostics is the easiest way to ensure proper communication between
the FACP and its various devices. To use the Diagnostics, you must be logged
in at a Level 4. Follow Steps 1 through 3 to run diagnostics on the 4010.
1. From the High-Level Status screen, press <MENU>.
2. Press <NEXT> or <PREVIOUS> until [Diagnostics] is displayed and then
press <ENTER>.
3. Press <NEXT> or <PREVIOUS> to select the desired diagnostic option
and then press <ENTER>.
The Diagnostic options are shown in Figure 10-1.
Figure 10-1. Diagnostic Options
Continued on next page
Diagnostics
Overview
Running Diagnostics
Software
Revision
• N2 Communications
• IDNet Earth Fault Search
• IDNet Diagnostics
• Network
Top Level Menus
Diagnostics
Set Time
and Date
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
