Simplex 4010 - Modifying a Card

5-5
Use the following steps to Modify a card in the 4010 FACP. The only cards you
can modify from this menu are the Dual RS232, Modem/RS232, and LCD
Annunciator cards.
1. Press <MENU>.
2. Press <NEXT> or <PREVIOUS> until [PROGRAMMING] is displayed
and then press <ENTER>. A warning appears, indicating that the 4010 is
no longer in the Fire Alarm Operation mode.
3. Press <ENTER> to continue.
4. Press <NEXT> or <PREVIOUS> until <CONFIGURE CARDS> is
displayed and then press <ENTER>.
5. Press <NEXT> or <PREVIOUS> until <MODIFY A 4010 CARD> is
displayed.
6. Press <NEXT> or <PREVIOUS> to scroll through the cards configured in
the 4010 FACP.
7. When the card you wish to modify is displayed, press Enter. The available
modifications you can make per card are shown in Table 5-2. The 4010
prompts you on which keys to press to execute different options.
Continued on next page
Adding, Deleting, or Modifying 4010 Cards, Continued
Modifying a Card
Pro
g
rammin
g
Please Wait . . .
Fire Alarm Operation Suspended
Technical Manuals Online! - http://www.tech-man.com