Simplex 4010 User Manual

6-18
This section describes how to configure a List.
Use the following steps to configure a List in the 4010 FACP.
1. Press <MENU>.
2. Press <NEXT> or <PREVIOUS> until [PROGRAMMING] is displayed
and then press <ENTER>. A warning appears, indicating that the 4010 is
no longer in the Fire Alarm Operation mode.
3. Press <ENTER> to continue.
4. Press <NEXT> or <PREVIOUS> until <CONFIGURE POINTS> is
displayed and then press <ENTER>.
5. Press <NEXT> or <PREVIOUS> to scroll through your choices until
<LIST> is displayed and then press <ENTER>.
6. Use <NEXT> or <PREVIOUS> to scroll through your lists until the
desired list is displayed and then press Enter.
7. Press <NEXT> or <PREVIOUS> to scroll through your list of choices until
the desired option is displayed and then press Enter. Your choices are
shown in Table 6-8.
Table 6-8. List Configuration Choices
Function Description
Add Point (See Note 2) Allows you to add specific point(s) to a List
Delete Point Allows you to delete specific point(s) from a List
Delete ALL Points Allows you to delete all points from a List
Edit Point Label (See Notes 1 and 3) Allows you to change the 40-Character label of
the List
Clear Point Label (See Notes 1 and 3)
Blanks the 40-Character Label of the List
Edit Point Type (See Notes 1, 2, and 3)
Changes the Point Type for the List
Notes:
1. This function not allowed for all Lists.
2. For a complete list of your choices for these edit functions, refer
to “Appendix B. Hardware and Pseudo Points.”
3. To complete these functions, refer to their appropriate section
in this publication.
Continued on next page
Configuring List Points
Overview
Configure a List
Please Wait . . .
Fire Alarm Operation Suspended
Technical Manuals Online! - http://www.tech-man.com

Simplex 4010 Specifications

General

Brand	Simplex
Model	4010
Category	Fire Alarms
Language	English