Simplicity 1695163 - Page 11

Install Latch & Hinge
9
A
F
B
Figure 14. Install Lower Discharge Chute 3A. Lower
Chute
B. Wing Nut
C. Rubber Strap
D. Carriage Bolt
E. Discharge Deflector
F. Deflector Hinge Rod
G. Bracket
LOWER DISCHARGE CHUTE INSTALLATION
1. Lift discharge deflector up (D, Figure 14).
2. Slide the notch of bracket (G) on to deflector hinge
rod (F).
3. Secure the front of lower chute (A) to carriage bolt
(D) using wing nut (B).
Note: Locknut (C) is intended to keep wing nut (B)
permanently on carriage bolt (D).
CONNECTING DISCHARGE TUBE
1. Slide discharge tube (B, Figure 15) into seal (C). It
may be necessary to lengthen several slits (F) in
order for tube (A) to fit into seal (B)
2. Attach the discharge tube (B, Figure 15 and Inset) to
boot (A) and secure the tube by moving wire form (E)
down over metal puck (D).
D
A
B
C
Figure 15. Install Discharge Tube
A. Boot
B. Discharge Tube
C. Seal
D. Puck, Metal
E. Wire Form
F. Slits
D
C
E
G
A
B
E
D
E
F