Figure 19. Seat Adjustment
Seat Adjustment
PITCH ADJUSTMENT
The pitch of the seat can be adjusted to one of three
positions. To adjust, remove the carriage bolts, spacers,
washers, and nuts (A, Figure 19) from the hinge and
reinstall them in the desired holes.
SEAT SLIDE ADJUSTMENT
The seat can also be adjusted forward and back. Move
the lever (B, Figure 19), position the seat as desired, and
release the lever to lock the seat into position.
SEAT SPRING ADJUSTMENT
The seat springs (C, Figure 19) can be adjusted to
provide a softer or firmer ride. Tilt the seat forward and
slide the spring assembly forward for a softer ride, and
back for a firmer ride.
B
A
B
MAINTENANCE
Figure 20. Transport Adjustment
C
B
A
E
D
Transport Adjustment
NOTE: Raising the trunnion on the J-hook will adjust the
deck to the highest position when it is lowered. Lowering
the trunnion on the J-hook will adjust the deck to the
lowest position when it is lowered.
1. Loosen jam nut (A, Figure 20).
2. Remove the hair pin (B) and washer (C) from trunnion.
3. Remove the trunnion (D), J-hook (E), and jam nut (A)
from mower lift arm.
4. Turn trunnion up or down to adjust height.
5. Place trunnion, J-hook, and jam nut in mower lift arm.
6. Install washer and hair pin. Tighten jam nut.
7. Check and adjust if necessary.
8. Repeat on other side.
26
To Next Page
Loading...
Need help?
General
