ackets should have a thread shank to
make them stand away from the fabric
Place a straight pin or sewing machine
needle on top of button between the
holes, and sew over the pin or needle.
Pull thread to back of button and wind
around stitches to form a firm shank.
Tie thread ends securely.
Presser foot……………. zigzag foot
Pattern selector ………. zigzag
Stitch length dial………. O
1. Align two holes of button with slot of
presser foot and lower foot to hold the
button securely.
2. Turn hand wheel manually until needle
point is just above button.
3. Adjust stitch selector so needle enters
right hole of button.
4. Turn hand wheel by hand so needle
enters second hole. The stitch selector
may need to be adjusted again. Stitch
a number of times.
NOTE:
You may find it helpful to use trans-
parent tape to position your button and
to keep it in place during sewing.
Tear away after stitching.
5. Finish sewing with an extra two inches
of thread remaining. Draw these
threads to reverse side of garment and
tie.
26
Retyped by Mastersewusa.com
To Next Page
Loading...
