EasyManua.ls Logo

Simplicity Broadmoor 1600 Series - Features & Controls; Tractor Controls Overview

Simplicity Broadmoor 1600 Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
REF NAME FUNCTION
A Choke (Twin Cylinder Only) Pull out to close choke. Aids in starting a cold engine.
B Engine Speed Control Lever Controls engine speed. On single cylinder models, push fully forward to close
choke. For warm starts & stopping, move control lever to START/STOP position.
C Headlight Switch Push front down to turn headlight on, push back to turn headlight off.
D Headlight Indicator Light (Blue) Indicates headlights on when lit.
E Oil Pressure Indicator Light (Red) Indicates low oil pressure (when engine is running). Lights up with ignition key
(not on Briggs & Stratton 15 HP) (L) turned on. Should go out immediately after engine starts.
F Operator Seated Indicator Light (Green) Indicates operator present and seat switch engaged. Must be lit for engine to
start. For more details, refer to Safety Interlock System.
G Neutral Indicator Light (Green) Indicates transmission lever (J) is in neutral gate. Must be lit for engine to start.
H PTO Indicator Light (Red) Indicates PTO switch (I) is on. Must be off for engine to start.,
I PTO (Electric Clutch) Switch Controls PTO for attachments. Pull up to engage clutch, push down to disen-
gage. Activates PTO light (H).
J Ground Speed Control Lever Controls ground speed and forward/reverse motion. Push forward to go
forward; pull back to go in reverse. On hydro models, ground speed is controlled
by how far lever is in forward or reverse position.
K Parking Brake Control Knob Engages parking brake. Depress clutch/brake pedal (N) fully and pull up knob to
engage parking brake. To disengage brake, depress pedal and push knob down.
L Ignition Switch Starts and stops the engine.
M Mower Lift Control Lever Lifts and locks mower into transport position when lever is raised and moved
into top position.
N Clutch/Brake Pedal Press down to disengage clutch and apply brake. For parking brake, depress
pedal fully and lift control knob (K). Pedal must be depressed to start tractor.
O Dual Position Steering Shaft Steering wheel can be installed in two different positions for operator
(Shown with steering wheel removed) comfort.
TRACTOR CONTROLS
Features & Controls
Figure 3. Tractor Controls (Hydro Model Shown)
*1953
C
B
A
D
I
G
H
J
K
N
M
L
E F
O

Table of Contents

Related product manuals