What to do if Simplicity LEGACY engine will turn over but will not start (Gas Models)?
If your Simplicity Lawn Mower engine turns over but doesn't start (Gas Models), begin by checking all wires and connections, and replace components as needed. Also, inspect the ignition switch, PTO switch, brake pedal switch, and seat switch; replace them if necessary. Finally, check the engine ignition system and replace components as required.
What to do if Simplicity LEGACY engine will turn over but will not start (Diesel Models)?
If your Simplicity Lawn Mower engine turns over but won't start (Diesel Models), you should check all wires and connections, replacing components as required. Inspect the ignition switch, PTO switch, brake pedal switch, and seat switch, replacing them if necessary. Also, check the preheat timer and glow plug relay, replacing them if needed. Finally, check the engine ignition system and replace components as required.
Why Simplicity Lawn Mower engine runs for a few seconds then dies (Gas Models)?
If your Simplicity Lawn Mower engine runs for a few seconds then dies (Gas Models), the issue might be with the ignition switch or the fuel system. Check the ignition switch and replace it if needed. Also, check the fuel system and replace components as required.
Why Simplicity Lawn Mower engine runs for a few seconds then dies (Diesel Models)?
If your Simplicity Lawn Mower engine runs for a few seconds then dies (Diesel Models), it could be due to the ignition switch or the fuel system. Check the ignition switch and replace it if necessary. Also, check the fuel system and replace components as required.
What to do if Simplicity LEGACY Lawn Mower battery is not charging?
If your Simplicity Lawn Mower battery isn't charging, it could be due to several reasons. Check for dirty or loose battery connections, or a worn battery; if found, replace the battery. A loose, broken, or dirty ground connection can also cause this, so clean both ends of the negative battery cable. A malfunctioning circuit breaker might be the issue, requiring you to replace it. Also, check the charging voltage, engine alternator, and ignition switch; if any of these are defective, replace the engine component.
What to do if Simplicity Lawn Mower PTO clutch will not engage (All Models)?
If the PTO clutch on your Simplicity Lawn Mower won't engage, check the PTO switch and replace it if necessary. Also, check the ignition switch and replace that if needed. Finally, inspect the PTO clutch itself and replace the PTO clutch assembly if it's faulty.
Why Simplicity Lawn Mower engine dies when brake pedal released (All Models)?
If your Simplicity Lawn Mower engine dies when the brake pedal is released, examine the brake pedal switch, seat switch, and PTO switch. Replace the brake pedal switch, seat switch, or PTO switch if necessary.
What causes Safety Interlock Malfunction in Simplicity LEGACY (All Models)?
A safety interlock malfunction in your Simplicity Lawn Mower can stem from several sources. It could be due to a seat switch safety interlock malfunction, requiring necessary repairs. Alternatively, it might be caused by a worn or malfunctioning seat switch, brake pedal switch, or cruise control switch, or a worn or failed PTO switch. In any of these cases, replace the respective switch.
Why Simplicity LEGACY battery over-charging (All Models)?
If your Simplicity Lawn Mower battery is over-charging, inspect the voltage regulator, alternator, and engine. Replace the defective engine component(s) as needed.
Why Simplicity Lawn Mower Headlights or Tail Lights don't operate (All Models)?
If the headlights or tail lights on your Simplicity Lawn Mower aren't working, start by checking for burned-out bulbs and replace them if necessary. Also, look for a loose, broken, or dirty ground connection and replace or repair any damaged ground connections. Other potential causes include dirty, loose, or worn battery connections (replace or repair battery cables or replace the battery), a dead battery (charge or replace the battery), loose, broken, or dirty connectors or wiring (replace or repair damaged wires or connectors), and a circuit breaker malfunction (replace the circuit breaker).
General| Engine Brand | Briggs & Stratton |
|---|---|
| Transmission | Hydrostatic |
| Deck Type | Fabricated |
| Cruise Control | Yes |
| Cutting Width | 52 in. |
| Turning Radius | 18 inches |
| Cutting Height | 1.5 - 4.5 in. |
| Deck Material | Steel |
| Warranty | 3 years |
To Next Page