Simplicity LEGACY Series User Manual

9 Drive Control Service
Introduction
9 - 8
REMOVE AND REPLACE
Introduction
The drive train consists of a piston type Sundstrand 15
series hydro pump and a Peerless 2600 transaxle. The
Legacy Tractor is equipped with a dual range system
(two speed transaxle) featuring a locking differential.
Figure 4. Drive Controls
Basic Checks
1. Check fluid level (see Section 3, MAINTENANCE).
2. Add fluid if needed.
3. Check for bulging in hydraulic hoses.
4. Start engine run for three minutes.
5. Turn key to stop.
6. Check for leaks.
7. Replace or repair any leaking hoses or fittings.
Not for Reproduction

Simplicity LEGACY Series Specifications

General

Engine Brand	Briggs & Stratton
Transmission	Hydrostatic
Deck Type	Fabricated
Cruise Control	Yes
Cutting Width	52 in.
Turning Radius	18 inches
Cutting Height	1.5 - 4.5 in.
Deck Material	Steel
Warranty	3 years