Pulley Stop Adjustment (48" Mower Only)
The pulley stop (A, Figure 10) prevents the idler pulley
from contacting the idler arm tension spring (B) when the
deck is engaged.
1. Remove the mower deck. See Mower Deck Removal
& Installation, in Section 18.
2. Remove the left side cover.
3. Loosen the idler pulley bolt and orient the pulley stop
(A) as shown in Figure 10.
Gauge Wheel Adjustment (54" Mower Only)
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher
cutting heights, set the wheels in the lower position.
When using lower cutting heights, set the wheels in the
upper position. To adjust:
1. Remove the hairpin clip (A, B, Figure 11).
2. For upper position, install the pin (A) through the spin-
dle above the bracket (C). For the lower position,
push down on the top of the spindle, and install the
hairpin clip (B) below the top of the bracket (C).
4 - 7
4 Adjustments
Mower Deck
Figure 10. Pulley Stop Position
A. Pulley Stop
B. Idler Arm Tension Spring
B
A
Figure 11. Gauge Wheel Adjustment
A. Hairpin Clip (Upper Position)
B. Hairpin Clip (Lower Position)
C. Gauge Wheel Bracket
A
B
C
To Next Page
Loading...
Need help?
General
