Figure 13. Mower Hitch
A. Tractor Hitch Brackets
B. Spring-Loaded Lever
Installing the Mower Deck
NOTE: Perform mower installation on a hard, level sur-
face such as a concrete floor.
1. Park the tractor, fully lower the attachment lift, turn off
the PTO switch, turn off the engine, remove the key,
and engage the parking brake. Turn the wheels fully
to the left.
2. Place mower in the lowest cutting position using the
mower height adjuster. Slide the mower deck under
the right side of tractor so that the mower hitch is
aligned with front tractor hitch (A, Figure 13).
3. See Figure 13. Turn wheels straight. Pull back on
the spring-loaded lever (B) while lifting up on the
mower hitch. Install the mower hitch onto tractor hitch
brackets (A). When properly installed, the spring-
loaded lever should seat fully underneath the brack-
ets (A).
4. See Figure 12. Connect the mower lift chains (B) to
the the tractor lift hooks (A).
NOTE: 50” & 54” Mowers: The four-link lift chain is bolt-
ed to the mower deck using the third link. This is correct
for most mowing applications. If mowing ditches or other
surfaces that require the mower to travel below its nor-
mal range, use the fourth link.
5. See Figure 12. From left side of tractor, use the idler
arm (D) to relieve belt tension. Install belt (C) onto the
PTO pulley.
6. If equipped, raise the attachment lift and rotate the
front gauge wheels (Figure 11) into cutting position.
NOTE: Units with electric height of cut, connect tractor
wire harness to deck harness.
To Next Page
Loading...
Need help?
General
