Simplicity LTH Series

Adjustments
9. U sing an open-end wrench, turn the hex shaft (D) three
turns upwards (toward the frame) if the tractor is
creeping forward, or downward (toward the ground) if
the tractor is creeping backwards.
10. H oid hex shaft and tighten front and rear nuts.
A. Quadrant
B. Transmission Engagement Lever
C. Taptite Screw
40
11. Repeat steps 1 through 7 to readjust the hydro iever in
the neutral gate.
12. Repeat entire procedure until tractor does not creep
with hydro lever in neutral gate.
A. Front Jam Nut
B. Rear Jam Nut
C. Hydro Shift Lever
D. Hex Shaft