Simplicity LTH Series

Adjustments
LARGE LIFT LEVER
NOTE
Use this procedure if optionai iarge iift iever (B, figure
8) is used, if smaii iift iever (E, figure 8) is used, see
previous procedure.
1. P iace the mower in iow cut position.
2. Measure the distance from bottom edge of iever bracket
to mower deck (figure 42).
3. The measurement shouid be 5 inches.
4. To adjust, disconnect trunnion (C, figure 43) from iift
chain. Loosen the nut, and turn trunnion to raise or iower
mower. Tighten nut when measurement is correct.
Figure 43. Lift Assembiy - Large Lift Lever
A. Chain
B. Nut
C. Trunnion
Figure 42. Measurement - Large Lift Lever
46