Assembling
Insert the leg buckles into the holes located on the base of the stove. Fasten the legs using
the screws ( 1 screw per leg ) and tighten with a Phillips head screwdriver, as followed
picture.
Operation Procedure
ON/OFF ------POWER
The power switch supplies power to all of the functions of the fireplace and will illuminate
the flame effect. This switch must be lit for any of the functions to work.
HEAT I
Low heater, Turn on this button the power is 750W.
HEAT II
HIGH heater, Turn on this button the power is 1500W.
To Next Page
Loading...
