SimpliFire SF-BI36-EB User Manual (English)

Other manuals for SimpliFire SF-BI36-EB

Questions and Answers:

A
Andrew JacksonAug 18, 2025
Why does my SimpliFire Fireplace Accessories remote control not work?
- S
  Stephen LindseyAug 18, 2025
  If the SimpliFire Fireplace Accessories remote control isn't working, first replace the batteries. If that doesn't solve the issue, make sure nothing is blocking the remote receiver and that you're close enough to the appliance. If equipped, ensure the appliance power switch is in the "I" position. If none of these steps work, the control board (PCB) may need to be replaced.
P
pruittmelissaAug 20, 2025
How to fix circuit breaker tripping when using SimpliFire Fireplace Accessories?
- T
  Tiffany ParrishAug 20, 2025
  If the circuit breaker trips or a fuse blows when you turn on your SimpliFire Fireplace Accessories unit, it's likely exceeding the current rating of the breaker or fuse. This can happen if other appliances are on the same circuit. To resolve this, install the unit on a dedicated 15 amp circuit.
K
Kevin WrightAug 23, 2025
What to do if SimpliFire Fireplace Accessories heater won't turn on?
- A
  Anne CraneAug 23, 2025
  If the heater on your SimpliFire Fireplace Accessories won't turn on but the flame is working, first check if the remote is in thermostat mode and if the room temperature is higher than the set point. If so, increase the thermostat set point or exit thermostat mode. If that's not the issue, the appliance may have overheated, tripping the safety thermal switch. Unplug the unit or turn off power at the circuit breaker and let it cool for 15 minutes, then restore power. If the problem continues, the main control board or the heater assembly might be defective and need replacement.
N
Nicole Lucas MDAug 26, 2025
Why do lights dim when SimpliFire Fireplace Accessories is on?
- B
  Benjamin JonesAug 26, 2025
  If the lights in the room dim when your SimpliFire Fireplace Accessories unit is on, it means the unit is drawing close to the circuit's current rating. To fix this, install the unit on a dedicated 15 amp circuit.
D
Dr. Dale Hicks MDAug 27, 2025
Why does my SimpliFire Fireplace Accessories heater shut off automatically?
- J
  Jordan DavilaAug 28, 2025
  If your SimpliFire Fireplace Accessories heater shuts off automatically or won't stay on, it could be because the room temperature is higher than the set point on the remote. Try increasing the thermostat set point or exiting thermostat mode. Alternatively, the appliance may have overheated, tripping the safety thermal switch. In that case, unplug the unit or turn off the power at the circuit breaker and let it cool down for 15 minutes before restoring power.
M
Mary GregoryAug 30, 2025
What to do if SimpliFire Fireplace Accessories won't turn on?
- T
  Tracy MontgomeryAug 30, 2025
  If your SimpliFire Fireplace Accessories won't turn on using the manual controls, first ensure it's plugged into a working electrical outlet. If it's hard-wired, double-check the wiring connections. Also, check the fuse/breaker panel for any issues. If none of these steps work, the control board (PCB) may be defective and need replacement.
E
Ellen FisherSep 1, 2025
Why is the flame not moving in my SimpliFire Fireplace Accessories?
- M
  michaelwongSep 1, 2025
  If the flame in your SimpliFire Fireplace Accessories isn't moving, try cycling the unit on and off. If the problem persists, inspect the rotisserie and motor for any blockages or interference. If you find none, the control board (PCB) and rotisserie motor may need to be replaced.
T
Tyler HarperSep 3, 2025
Why doesn't the ember bed light up on my SimpliFire Fireplace Accessories?
- K
  Kyle CoxSep 4, 2025
  If the ember bed on your SimpliFire Fireplace Accessories isn't lighting up, refer to the operation section of the user manual. Also, check the wiring to the ember bed LEDs to ensure they are properly connected. If the wiring is secure, the control board (PCB) or the LED lights themselves may be defective and require replacement.
C
Carolyn MorenoSep 6, 2025
Why is the flame shuddering in my SimpliFire Fireplace Accessories?
- S
  stanley21Sep 6, 2025
  If the flame in your SimpliFire Fireplace Accessories is shuddering, ensure the flame rod is straight, properly mounted, and spinning freely without hitting other components. If that doesn't solve the issue, the flame rotisserie motor might be defective and need replacement.
D
Diana MartinSep 8, 2025
Why is my SimpliFire Fireplace Accessories heater so noisy?
- J
  jaredsimonSep 8, 2025
  If your SimpliFire Fireplace Accessories is making excessive noise when the heater is on, inspect the heater assembly and fan for any obstructions or interference. If there are no obstructions, the blower motor may be defective and the heater assembly may need to be replaced.

SimpliFire SF-BI36-EB Specifications

General

Type	Electric Fireplace
Size	36 inches
Installation	Built-in
Power Source	Electric
Flame Effect	LED
Remote Control	Yes
Voltage	120V
Thermostat	Yes
Safety Features	Overheat Protection
Fireplace Type	Electric
Power Consumption	1400 Watts