1
SimpliFire • Wall Mount Bracket Kit • 2040-930 Rev. B • 9/19
Wall Mount Bracket Kit
BRACKET-ALL48, BRACKET-ALL60, BRACKET-ALL84
Model: SF-ALL40-BK, SF-ALL48-BK, SF-ALL60-BK, SF-ALL84-BK,
SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK
- Instructions -
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation and service. Sheet metal edges are sharp.
Leave this manual with party responsible for use
and operation.
WARNING! Risk of Shock! Always unplug the cord or
turn off the circuit breaker before moving or servicing.
Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Needle-nose pliers
Hammer
Gloves
Level
Phillips screwdriver
Safety glasses
Drill
1/2 in. drill bit for 3/16 in. diameter toggle bolts
(applicable if installing on drywall-sheathed walls)
Masonry drill bit 5/16 in. (applicable if installing on
masonry walls)
WARNING! Risk of Personal Injury or Property Dam-
age! Failure to follow instructions below may result in
damage to the equipment and or may expose the user to
the risk of re, serious injury, illness or death.
Kit Contents:
• Wall Mount Bracket
• (8) Toggle Bolts
• (8) Masonry Anchors
• (8) ST6X50 Screws
• (2) M5X10 Screws
Introduction
This kit provides installation instructions for the wall mount
bracket kit.
Appliance Kit Sku
Minimum
# of Anchors
Required
SF-ALL40-BK
SF-ALL48-BK
SFALLP50-BK
BRACKET-ALL48 6
SF-ALL60-BK
SF-ALLP60-BK
BRACKET-ALL60 6
SF-ALLP72-BK BRACKET-ALL60 8
SF-ALL84-BK BRACKET-ALL84 8
Table 1
BRACKET-ALL48 & BRACKET-ALL60 Kit also includes:
• Side Panels (1-right side, 1-left side)
• (4) ST4X8 Screws
To Next Page
Need help?
General
