Simpson 260 Series - Page 56

Operator Servicing
ом
Вац
1A
Fuse
6-111574
ZN WARNING
To avoid electric shock, make certain that the test leads are disconnected from any cir-
cuits before removing the battery and fuse compartment cover. Do not attempt any
further dissassembly. No other user serviceable parts inside. Refer servicing to
qualified personnel only.
CARELESSNESS AND MISUSE OF THIS INSTRUMENT CAN BE DANGEROUS
Before connecting this instrument, carefully read the instructions and precautions in
! the Operator's Manual. Failure to follow instructions can result in a serious or fetal
injury.
eiu SAFETY TIPS
1. Do not attempt any measurements unless trained, qualified and authorized to do so.
| 2. Do not connect to any circuit where the voltage with respect to earth ground may
exceed 1000 volts.
3. Whenever making measurements with this instrument, —
. Turn OFF circuit power and discharge any capacitance in the circuit before con-
necting or disconnecting test leads or changing switch settings.
. Double-check for correct switch settings and test lead connections before apply-
ing power.
» Do not touch the instrument, test leads or the circuit while power is ON
. Do not use any instrument or test leads that are damaged, contaminated,
deteriorated, moist, or which have missing parts
. Voltages as low as 30 volts r.m.s. or 42.4 volts peak can render an electric shock
Read the Operator's Manual for additional precautions and instructions
FIGURE 5-1. BATTERY AND FUSE COMPARTMENT
5-3