14
6. Select the programme and start the
machine
Turn the programme selector dial clockwise to the
required programme and press the ON/OFF button
: the mains on light comes on and the machine
starts to operate.
Important!
• Do not try to open the door while the machine is in
operation. If you need to open after the machine
has been switched on, first switch it off and wait of
about two minutes.
• When opening the door, be careful, as the water
level may be high and water may pour out when
you open the door.
7. At the end of the programme
The machine stops automatically.
45 S 508 D - 45 S 551 D
If you have selected a programme which ends with
the water of the last rinse left in the tub (programmes
G - H - K - L - M), drain the water before opening the
door. Select programme “N” (drain) or “J” (short
spin).
45 S 651 D
If you have selected option
,
the water of the last
rinse must be emptied out by selecting programme
“N” (drain) or by depressing button again (after
draining, the spin will performed).
Wait one or two minutes before opening the door to
give the electric locking mechanism time to release
it.
This is a safety feature to ensure that the wash bowl
has finished spinning.
Depress the ON/OFF button again to switch the
machine off. The mains on light goes out.
Remove the laundry.
Turn the drum by hand to make sure it is completely
empty, so as to avoid any forgotten items being
damaged in a subsequent wash (e.g. shrinking) or
their colour running into a load of whites.
Release any buttons which have been pressed.
Turn the water taps off and unplug the machine.
Leave the door ajar to air the machine.
To Next Page
Loading...
