Simpson SWT704 User Manual (English)

Questions and Answers:

M
Michael GallowayAug 15, 2025
Why is my Simpson SWT704 Washer machine not working?
- M
  Matthew JohnsonAug 15, 2025
  Your Simpson Washer might not be working due to several reasons: * The power may not be switched on; ensure the power point is on. * There might be no electricity supply; test the power point with another appliance. * The water taps might not be turned on; turn them on. * An out-of-balance switch might be activated; open the lid, redistribute the load, and close the lid. * The lid might not be fully closed; ensure it is closed properly.
A
Ashley RodgersAug 18, 2025
What to do if Simpson SWT704 machine has washed load but will not spin?
- A
  Amy BarkerAug 18, 2025
  If your Simpson Washer has washed the load but won't spin, it could be because the load is out of balance. Open the lid, redistribute the load, and then close the lid. Alternatively, the lid may not be fully closed; ensure that the lid is properly closed.
H
Holly FieldsAug 21, 2025
What to do if water on floor near Simpson SWT704 Washer?
- K
  Kimberly AllenAug 22, 2025
  If water is pouring onto the floor near your Simpson Washer, turn OFF both wall taps.
J
John RoyAug 25, 2025
How to fix Simpson Washer that will not fill with water?
- M
  Michael EscobarAug 26, 2025
  If your Simpson Washer is not filling with water, it could be due to several reasons: * The water taps may not be turned on; turn the taps on. * The inlet hoses may be blocked; clean the tap filters/washers. * There might be too much water for the load size; use a low water level. * The water level might be incorrect for the size of the load; check detergent use and rewash.
F
fmullenAug 28, 2025
What to do if water flowing into Simpson SWT704 washbowl indefinitely?
- M
  Melvin GonzalezAug 28, 2025
  If water is flowing into your Simpson Washer washbowl indefinitely, it may be because the drain hose is blocked. Check the drain hose for any blockage.
J
Joshua CruzSep 1, 2025
What to do if my Simpson SWT704 clothes still dirty after wash program?
- J
  jerry72Sep 1, 2025
  If your clothes are still dirty after the wash program in your Simpson Washer, it could be due to: * Too many suds causing motor temperature overload; reduce detergent dose or use low sudsing detergent in the future. * Not enough or no detergent; check detergent use and rewash. * Too many clothes in the load; remove some clothes and rewash. * Incorrect wash program or temperature selected; reselect the program or temperature and rewash.
C
Caleb SmithSep 3, 2025
Why Simpson SWT704 Washer machine goes out of balance or vibrates excessively when spinning?
- P
  parkerericSep 3, 2025
  Your Simpson Washer may be going out of balance or vibrating excessively due to: 1. The machine not being level; make sure the machine is level. 2. Levelling feet not adjusted; adjust the feet to touch the floor. 3. Clothes not evenly distributed; redistribute the clothes evenly.
A
Amanda CaseySep 7, 2025
What causes scraping noise on spin in Simpson SWT704?
- M
  Michael WhitneySep 7, 2025
  A scraping noise during the spin cycle in your Simpson Washer is caused by a bra wire or other thin items caught between the inner and outer washbowls. If the item is visible, remove it with pliers. Consider using a wash bag in the future.