8
ADD THE DETERGENT
1. Measure the correct amount of powder or liquid detergent by
following the recommendations on the package.
2. Mix detergent in one litre of hot or warm water.
3. Add the pre-mixed detergent to the wash load.
Don’t do these things:
* Using too little detergent will give you a poor wash result.
* Using excessive detergent will create to many suds and may cause
overloading of the motor during the spin stage of the wash cycle.
To avoid excessive suds, reduce the amount of detergent you use.
It is best to use detergent labelled low sudsing.
Good quality, front load detergent will perform well in this machine.
* Use soap based products in your washing machine.
ADD FABRIC SOFTENER
1. Measure the correct amount of fabric softener by following the
recommendations on the package.
2. Mix softener with an equal amount of warm water but only mix
enough to fill to the line marked inside the
cup. The softener cup
holds 75ml.
3. Pour the mixed softener into the cup in the top of the agitator.
Do not overfill the cup.
4. Do not spill fabric softener on the clothes as it may stain them.
IMPORTANT: If you are going to use fabric softener, you must select
the DEEP RINSE option, i.e deselect the ECO RINSE option.
Also if softener is used frequently the machine must be flushed out
regularly refer Page 18.
NOTE: You do not have to use fabric softener, your washing machine
will wash the clothes perfectly well without it.
ADDING BLEACH
Bleaching of clothes can help to remove stains, heavy soiling and
to kill bacteria.
Oxygen type - This is generally a powder type bleach.
Mix the required quantity with water and pour down the hole in the
top panel during the fill when there is some water in the wash bowl.
Refer to the instructions on the bl
each container.
Chlorine type - This type of bleach should not be mixed with detergent.
Mix the bleach with water as per the instructions on the container.
Turn PROGRAM SELECTOR to a Regular Wash position.
Press the START/PAUSE button to commence water fill.
Pour the bleach solution down the hole in the top panel during fill
when there is some water in the wash bowl.
Allow the machine to agitate for a few minutes, then let it stand for
the required time by pressing the START/PAUSE button.
Turn PROGRAM SELECTOR to Drain & Spin
position and press the
START/PAUSE button to empty the wash bowl.
You can now wash the clothes load using detergent and your selected
wash program.
NOTE: Bleach should not be used on silk, wool, rayon or drip dry
clothes.
To Next Page
Loading...
