Why is my Simpson SWT7055LMWA Washer machine not working?
If your Simpson Washer isn't working, start by ensuring the power is switched on at the power point. If it is, check the power point with another appliance to confirm there's an electricity supply. Also, make sure the water taps are fully turned on.
What to do if Simpson SWT7055LMWA won't spin but has washed load?
If your Simpson Washer has completed the wash but won't spin and there's still water in the wash bowl, it could be due to an unbalanced load. Open the lid, redistribute the load, and close the lid. Make sure the lid is fully closed. Check the drain hose for any blockages. Wait a short while, press start to continue.
What to do if Simpson SWT7055LMWA will not fill with water?
If your Simpson Washer will not fill with water, begin by ensuring that the water taps are turned on. If they are on, check the inlet hoses for any blockages and clean the inlet hose filters.
What to do if my Simpson SWT7055LMWA is not filling with water?
Make sure both taps are on and hose filters are not blocked. Raise drain hose if water is flowing out of drain hose. Press “Start/Pause” to re-start wash. If problem remains, call Service.
How to solve draining problem in Simpson SWT7055LMWA?
Wait a few minutes to see if the fault is corrected. If not, set the washing machine to PAUSE by press “Start/Pause” button then check the drain hose for blockage. Press “Start/Pause” to continue the wash. If problem remains, call Service.
What to do if my Simpson SWT7055LMWA Washer goes out of balance?
If your Simpson Washer is vibrating excessively or going out of balance during spinning, ensure the machine is properly leveled. Check that the leveling feet are adjusted to touch the floor. Additionally, redistribute the clothes evenly inside the washer.
How to fix water on floor from Simpson SWT7055LMWA Washer?
If your Simpson Washer has water on the floor, inspect the inlet hose connections at both the taps and the rear of the machine to ensure they are tight. Also, check the drain hose connections at the rear of the machine for any looseness.
Why are clothes still dirty after wash completed in my Simpson Washer?
If clothes are still dirty after the wash cycle in your Simpson Washer, ensure you are using enough detergent. You may need to rewash the clothes. Avoid exceeding the maximum load capacity; remove some clothes and rewash if necessary. Also, verify that you've selected the correct wash program and temperature for the load; reselect if needed and rewash.
Why is there water splash from my Simpson SWT7055LMWA Washer?
If you notice water splashing from your Simpson Washer, make sure the machine is properly leveled. Also, consult page 9 for the correct water level selection based on your load size.
Why is there a scraping noise on spin in my Simpson Washer?
If you hear a scraping noise on spin in your Simpson Washer, it might be due to a bra wire or other thin item caught between the inner and outer washbowls. If the item is visible, try to remove it with pliers. Consider using a wash bag in the future to prevent this.
General| Model | SWT7055LMWA |
|---|---|
| Type | Top Load Washer |
| Capacity | 7.0 kg |
| Color | White |
| Wash Programs | Delicate, Rinse & Spin |
| Dimensions (H x W x D) | 575 mm |
To Next Page
