What to do if my Simpson Washer is losing water while washing?
If water level in wash bowl is low and water is flooding the floor, rotate the PROGRAM KNOB to “Drain + Spin” program, then press “Start/Pause” button. Should this make things worse, turn off the machine and call Service. Otherwise, press “Start/Pause” to continue the wash.
What to do if Simpson SWT6041 won't spin and has water in it?
If your Simpson Washer has washed the load but won't spin and there's still water in the wash bowl, the issue could be due to: 1. An out-of-balance load: Open the lid, redistribute the load, and close the lid. 2. The lid not being fully closed: Ensure the lid is completely closed. 3. A blocked drain hose: Check the drain hose for any blockages. After checking the drain hose, wait a short while; the wash should continue.
Why won't my Simpson Washer fill with water?
If your Simpson Washer will not fill with water, make sure that the water taps are turned on. Also, check the inlet hoses for any blockages and clean the tap filters/washers if necessary.
Why Simpson SWT6041 won't spin but has water in the bowl?
If your Simpson Washer has washed the load but won't spin and there's water in the wash bowl, the load might be out of balance. Open the lid, redistribute the load, and close the lid. Also, ensure the lid is fully closed. A blocked drain hose can also cause this issue, so check it for blockages. After checking, wait a short while for the wash to continue.
Why is my Simpson SWT6041 Washer not filling with water?
Make sure both wall taps are on and hose filters are not blocked. Raise drain hose if water is flowing out of drain hose. Press “Start/Pause” to re-start wash. If problem remains, call Service.
Why Simpson SWT6041 Washer makes scraping noise on spin?
If you hear a scraping noise during the spin cycle of your Simpson Washer, it could be due to a bra wire or other thin item caught between the inner and outer washbowls. If the item is visible, try to remove it with pliers. Consider using a wash bag in the future to prevent this.
How to fix Simpson Washer that vibrates excessively?
If your Simpson Washer goes out of balance or vibrates excessively during spinning, ensure the machine is level. Adjust the levelling feet so they touch the floor. Also, redistribute the clothes evenly inside the washer.
Why is water constantly flowing into my Simpson Washer?
If water is flowing into the wash bowl of your Simpson Washer indefinitely, it could be due to the drain hose being too low. Raise the drain hose or fit a syphon break. Refer to the installation instructions for the correct positioning of the hose.
Why does water keep flowing into my Simpson SWT6041?
If water is flowing into the wash bowl of your Simpson Washer indefinitely, the drain hose might be too low. Raise the drain hose or fit a syphon break. Refer to installation instructions for correct positioning of the hose.
What to do if my Simpson SWT6041 has a water level problem?
Wait, this fault may clear itself. If not, rotate the PROGRAM KNOB to “Drain + Spin” program, then press “Start/Pause” button to drain the wash bowl. If this problem is repeated, call Service.
To Next Page
General
