Simpson SWT604 User Manual (English)

Questions and Answers:

M
Mr. Stephen CollinsAug 15, 2025
Why is my Simpson SWT604 Washer machine not working?
- J
  john66Aug 15, 2025
  Your Simpson Washer might not be working due to several reasons: * The power may not be switched on; ensure the power point is on. * There might be no electricity supply; test the power point with another appliance. * The water taps might not be turned on; turn them on. * An out-of-balance switch might be activated; open the lid, redistribute the load, and close the lid. * The lid might not be fully closed; ensure it is closed properly.
A
Anita DennisAug 18, 2025
What to do if Simpson SWT604 Washer machine has washed load but will not spin?
- B
  Brenda McintyreAug 18, 2025
  If your Simpson Washer has washed the load but won't spin, it could be because the load is out of balance. Open the lid, redistribute the load, and then close the lid. Alternatively, the lid may not be fully closed; ensure that the lid is properly closed.
R
Raven HudsonAug 22, 2025
What to do if water on floor near Simpson SWT604?
- A
  Amy FloresAug 22, 2025
  If water is pouring onto the floor near your Simpson Washer, turn OFF both wall taps.
D
doylejacobAug 25, 2025
How to fix Simpson SWT604 that will not fill with water?
- P
  Paul SandersAug 26, 2025
  If your Simpson Washer is not filling with water, it could be due to several reasons: * The water taps may not be turned on; turn the taps on. * The inlet hoses may be blocked; clean the tap filters/washers. * There might be too much water for the load size; use a low water level. * The water level might be incorrect for the size of the load; check detergent use and rewash.
K
Kimberly DorseyAug 28, 2025
What to do if water flowing into Simpson SWT604 Washer washbowl indefinitely?
- M
  Morgan PetersonAug 28, 2025
  If water is flowing into your Simpson Washer washbowl indefinitely, it may be because the drain hose is blocked. Check the drain hose for any blockage.
A
allisonbakerAug 31, 2025
What to do if my Simpson SWT604 Washer clothes still dirty after wash program?
- V
  Victoria WhiteAug 31, 2025
  If your clothes are still dirty after the wash program in your Simpson Washer, it could be due to: * Too many suds causing motor temperature overload; reduce detergent dose or use low sudsing detergent in the future. * Not enough or no detergent; check detergent use and rewash. * Too many clothes in the load; remove some clothes and rewash. * Incorrect wash program or temperature selected; reselect the program or temperature and rewash.
B
browntyroneSep 4, 2025
Why Simpson SWT604 machine goes out of balance or vibrates excessively when spinning?
- J
  James BurkeSep 4, 2025
  Your Simpson Washer may be going out of balance or vibrating excessively due to: 1. The machine not being level; make sure the machine is level. 2. Levelling feet not adjusted; adjust the feet to touch the floor. 3. Clothes not evenly distributed; redistribute the clothes evenly.
M
mmortonSep 7, 2025
What causes scraping noise on spin in Simpson Washer?
- E
  Evan ComptonSep 7, 2025
  A scraping noise during the spin cycle in your Simpson Washer is caused by a bra wire or other thin items caught between the inner and outer washbowls. If the item is visible, remove it with pliers. Consider using a wash bag in the future.