Why is my Simpson SWT6041 Washer splashing water?
If you are experiencing water splash from your Simpson Washer, it may be due to too many clothes in the machine. See maximum clothes load on page 9. Also, make sure that your machine is levelled properly. Finally, ensure that your water level selection is correct. See water level description on page 9.
Why is my Simpson SWT6041 not working?
If your Simpson Washer isn't working, here's what to check: * First, ensure the power is switched on at the power point. * Test the power point with another appliance to confirm it's supplying electricity. * Make sure the water taps are turned on. * If the washer switched off due to being out of balance, open the lid, redistribute the load, and close the lid. * Confirm that the lid is fully closed.
Why are clothes still dirty after wash in my Simpson SWT6041?
If your clothes are still dirty after running a wash program in your Simpson Washer, it could be due to not using enough or any detergent. Check the detergent usage and rewash the clothes. Also, make sure that you don't put too many clothes in the load. Finally, ensure that you have selected the correct wash program and temperature; if not, reselect and rewash.
What to do if my Simpson SWT6041 has a water level problem?
Wait, this fault may clear itself. If not, rotate the PROGRAM KNOB to “Drain + Spin” program, then press “Start/Pause” button to drain the wash bowl. If this problem is repeated, call Service.
What to do if my Simpson SWT6041 has a draining problem?
Wait a few minutes to see if the fault is corrected. If not, set the washing machine to PAUSE by press “Start/Pause” button then check the drain hose for blockage. Press “Start/Pause” to continue the wash. If problem remains, call Service.
What to do if clothes are still dirty after washing in Simpson SWT6041 Washer?
If your clothes are still dirty after a wash program in your Simpson Washer, make sure you're using enough detergent. If not, add more and rewash the clothes. Also, avoid overloading the machine by removing some clothes and rewashing. Finally, ensure you have selected the correct wash program and temperature for the load.
Why is there water on the floor near my Simpson SWT6041?
If you find water on the floor near your Simpson Washer, check the inlet and drain hose connections at both the taps and the rear of the machine to ensure they are not loose. Condensation from hot water can also be a cause.
How to fix a Simpson SWT6041 that vibrates excessively?
If your Simpson Washer vibrates excessively or goes out of balance during the spin cycle, it might not be level. Ensure the machine is level and that the leveling feet are adjusted to touch the floor. Also, redistribute the clothes evenly inside the washer.
Why is my Simpson SWT6041 Washer not filling with water?
Make sure both wall taps are on and hose filters are not blocked. Raise drain hose if water is flowing out of drain hose. Press “Start/Pause” to re-start wash. If problem remains, call Service.
Why Simpson SWT6041 won't spin but has water in the bowl?
If your Simpson Washer has washed the load but won't spin and there's water in the wash bowl, the load might be out of balance. Open the lid, redistribute the load, and close the lid. Also, ensure the lid is fully closed. A blocked drain hose can also cause this issue, so check it for blockages. After checking, wait a short while for the wash to continue.
To Next Page
General
