If you have frequent out of balance interruptions, it may be due to your washing machine
not standing firm and level on the floor.
This can be corrected by adjusting the washing machine legs as described in the
Installation Instructions supplied with your machine.
Button response and lights
Always press buttons gently.
Watch the lights on the control panel to see the effect pressing a button or turning a program
selector knob has, and listen for ‘BEEPS’.
When you press a button you will get a short ‘BEEP’ to acknowledge the entry. If the option
is not available at the time, the machine will not allow you to select it. After the machine has
started, the entire wash option button will be disabled and machine will show “ ” on the
display with three short beeps to indicate the button is disabled. The start button is still active
but you need to press and hold the button for 1.2 seconds to pause machine. This is to confirm
that you really want to pause the machine. When in pause mode, all options will be able to be
changed again.
NOTE: All functions of the wash
ing machine will stop when the lid is open, except for pump out
before spin.
To Next Page
Loading...
