EasyManua.ls Logo

Simpson MS60753 - User Manual

Simpson MS60753
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Table of Contents

Questions and Answers

  • L
    Logan MorenoAug 11, 2025
    How to fix Simpson MS60753 Pressure Washer engine that will not start?
    • B
      Brad CastroAug 11, 2025
      If your Simpson Pressure Washer's engine won't start, several factors could be the culprit. First, ensure you have fresh fuel in the tank. If pressure has built up after a couple of pulls on the recoil starter, squeeze the gun trigger to relieve it. Check that the choke lever is correctly positioned—use the "Choke" position for a cold engine and the "No Choke" position for a hot engine. Also, verify the spark plug wire is securely attached and the engine switch is in the ON position.
  • D
    Dennis SmithAug 17, 2025
    Why Simpson MS60753 Pressure Washer has no or low pressure on initial use?
    • C
      Charles BakerAug 17, 2025
      If your Simpson Pressure Washer has no or low pressure upon initial use, ensure the choke is in the “No Choke” position. Also, verify that you are using a high-pressure hose under 100 feet (30 m).
  • P
    Paul YoungAug 22, 2025
    Why my Simpson Pressure Washer will not draw chemicals?
    • A
      allenscottAug 23, 2025
      If your Simpson Pressure Washer isn't drawing chemicals, make sure the spray wand is set to low pressure. Check and clean the chemical filter if it's clogged. Ensure the detergent siphon hose is fully submerged in the cleaning solution, and that the chemical isn't too thick—dilute it to the consistency of water if necessary. Also, use a shorter high-pressure hose and lengthen the water supply hose instead.
  • S
    Steven LewisAug 29, 2025
    What to do if Simpson MS60753 Pressure Washer is leaking at gun/spray wand connection?
    • A
      Ashley LucasAug 29, 2025
      If your Simpson Pressure Washer is leaking water at the gun/spray wand connection, check for a worn or torn o-ring and replace it if necessary. Also, ensure the hose connection is tight.
  • J
    Jose MorganSep 3, 2025
    Why does the pump pulsate on my Simpson Pressure Washer?
    • E
      espinozabrianSep 4, 2025
      If the pump of your Simpson Pressure Washer pulsates, the nozzle might be obstructed. Refer to the Nozzle Cleaning paragraph in the Maintenance section for the correct procedure.

Simpson MS60753 Specifications

General IconGeneral
Hose Length25 ft
Pump TypeAxial Cam
Wheel Size10 in
Warranty2 years
Engine208cc OHV Engine
PumpAxial Cam
Nozzles Included0°, 15°, 40°, Soap

Related product manuals