NOTICE: Risk
of
property damage. Never
pull
water supply hose to move pressure
washer.
This
could
damage hose and/or
pump
inlet.
•
00
NOT use hot
water,
use cold water
only.
• Never tum water supply
off
while pressure washer engine is running
or
damage to
pump will result.
• DO NOT stop spraying water for more than two minutes
at
a
time.
Pump operates
in
bypass mode when spray gun trigger is
not
pressed.
If
pump is left
in
bypass
mode for more than two minutes internal components
of
the pump can
be
damaged.
If
you
do
not
understand these precautions, please contact
our
customer service
department
at
www.simpsoncleaning.com
Prior
to
starting,
refer
to
your
engine
manual
for
proper
starting
procedure.
1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline
with a pump octane rating
of
86
or
higher. Do
not
overfill. Wipe
up
spilled
fuel
before starting
the
engine. Refer
to
Engine
Owner's
Manual
for correct
procedure.
--Ethanol
Percentage
--
NOTICE: Use
of
fuels with greater than
10%
ethanol are
Slo%~
T
~
15
%_
30
%-
85
% l
not
approved for use
in
. this product
per
EPA
regulations
X:
W l W
')and
will damage the unit
and
void the
warranty.
2.
Check engine oil level. Refer
to
Engine
Owner's
Manual
for
correct procedure.
3. Connect the water hose to the water source. Turn the water source
on
to
remove all air from the hose. When a steady stream
of
water
is
present, turn
the water source off.
4.
Verify the filter screen
(Q)
is
in
water inlet
of
pump. NOTE: Convex side faces
out.
5. Connect water source
(N)
to pump inlet
(J).
NOTE: Water source must provide
a minimum
of
5 gallons per minute
at
20
PSI.
6.
Connect high pressure hose
(C)
to
pump outlet
(1)
.
•
& WARNING:
To
reduce
the
possibility
of
contamination
always
protect
against
backflow
when
connected
to
a
potable
water
system.
7.
Choose the correct nozzle for the
job
to
be
performed. See
How
To
Use
spray
Wand instructions in this section. NOTE:
If
applying a chemical
or
cleaning
solution, see
How
To
Apply
Chemicals/Cleaning
Solvents instructions
in
this
section.
8. Turn water source on.
NOTICE: Risk
of
property damage. Failure to do
so
could
cause damage to the
pump.
9.
Remove all air from the pump and high pressure hose
by
depressing trigger
until a steady stream
of
water is present.
10. Start engine. See Engine
Owner's
Manual
for
correct procedure.
15-
ENG
To Next Page
Loading...
